As the automotive industry moves forward with “smart” and autonomous vehicles, it is important as ever to test automobiles for electrical, radiated, and magnetic interference. The goal is to test the components in order to eliminate EMI (electromagnetic interference) in automotive vehicles.
CISPR(International Special Committee on Radio Interference),ISO (International Organization for Standardization), and SAE (Society of Automotive Engineers) are the main developers of automotive standards relating to EMC. SAE mainly develops standards for use in North America, where CISPR and ISO create standards that are used internationally. Most standards for CISPR, ISO, and SAE are broken into two categories, vehicle and component. Each vehicle manufacturer will have its own internal corporate standards that will specify the levels and testing required for components used in their vehicles.
Avalon Test Equipment carries a wide variety of automotive test solutions to meet specific test standards. Rent or purchase from Avalon and Test With Confidence®.
The UCS 200N100 by EM Test is in stock and ready to rent! The Ultra-Compact Simulator series for Automotive Transients unifies the capabilities of an EFT/Burst simulator, a Micro-pulse simulator, and the required coupling network into one box. Lab staff with over 20 years of technical experience. Customer service is our top priority. Immediate sales assistance along with same day shipments. Rent from Avalon Test Equipment.
The EM Test ESD NX30 is an ESD tester to simulate ESD pulses at higher voltages up to 30 kV in both air and contact discharge mode. It satisfies requirements exceeding the EN/IEC 61000-4-2 test levels and complies with automotive test applications.
The VDS 200N series is used to simulate the various battery supply waveforms recommended by international standards and by car manufacturer requirements.
The VDS 200Q series is used to simulate the various battery supply waveforms recommended by international standards and by car manufacturer requirements. Available to rent!
The three-phase coupling/decoupling networks of the coupling NX series are used to couple EFT/Burst-, Surge- and Ring wave pulses on DC-lines or to three-phase (4-wire or 5-wire) mains supply systems for voltages up to 1,000 VDC / 3 x 690 VAC.
The R&S® ESU is a family of CISPR 16-1-1-compliant EMI test receivers that meet all civil and military standards for electromagnetic disturbance measurements.
The A.H. Systems Double Ridged Guide Horn is a broadband antenna that offers excellent performance over the frequency range of 18GHz to 40GHz. High gain, low VSWR, input handling capability up to 10 watts CW and rugged design make this horn antenna excellent for both immunity and emissions testing.
Narda-STS NBM-520 is the most accurate non-ionizing radiation survey system available. It provides broad frequency coverage of electric and magnetic fields.
The PFS 200N Series Automotive Power Fail simulator is used to comply with standard requirements, mainly from vehicle manufacturers, to perform fast voltage dips ad drops (micro-interruptions). Some standards specify very fast rise and fall times below 1 microsecond an electronic switch.
The PFS 200N Series Automotive Power Fail simulator is used to comply with standard requirements, mainly from vehicle manufacturers, to perform fast voltage dips ad drops (micro-interruptions). Some standards specify very fast rise and fall times below 1 microsecond an electronic switch.
Included in base system: HV Supply, Processor, Power Entry Module, RS232 Interface, IEEE Interface, CDN 5500 100A coupler, FT 5530 Fast Transient Generator, Autostar Software, traceable calibration certificate.