EMI (electromagnetic interference) can be dangerous for automotive vehicles as it can damage electrical systems and cause a vehicle to run out of control. Test solutions have been put in place to test possible interferences and create safer vehicles.
Avalon Test Equipment carries a wide variety of automotive test solutions from leading manufacturers such as EM Test, R&S, and Teseq. Search by your test solution requirement for equipment available to rent or purchase and Test With Confidence®.
Key applications of the CWS 500N3 are in the automotive and aerospace area. Various international standards and MIL requirements call for magnetic field tests in the low frequency range. Apart from this the automotive industry requires conducted immunity tests with superposed sinusoidal signals on the DC supply voltage (ripple noise). For both applications the CWS 500N3 is the perfect equipment including everything in a single box, necessary for these tests. The CWS 500N3 meets requirements of SAE J1113-2, ISO 11452-8, DO 160D/E Section 18 and MIL-STD-461 D/E/F/G CS101, CS109 and RS101.
The PFS 200N Series Automotive Power Fail simulator is used to comply with standard requirements, mainly from vehicle manufacturers, to perform fast voltage dips ad drops (micro-interruptions). Some standards specify very fast rise and fall times below 1 microsecond an electronic switch.
The EM Test PFS 200N30 automotive power fail simulator for voltage dips and interruptions is used to comply with standard requirements including ISO 16750-2, mainly from vehicle manufacturers, to perform fast voltage dips ad drops (micro-interruptions). Some standards specify very fast rise and fall times below 1 microsecond an electronic switch.
Early evaluation of your design's EMI performance is essential for a successful product. The Keysight E7402A EMC Spectrum Analyzer is part of the E7400A Series which provides the capabilities you need in an analyzer to make in-house EMI pre-compliance testing a reality.
The Narda Industrial Meter NIM is a complete measuring system with combined E and H field probe for simultaneous measurement of electric and magnetic fields on equipment operating at ISM frequencies. NIM-511, calibrated at the 13.56 MHz ISM frequency, covers a wide frequency range of industrial equipment. The device was specially developed for measurements on industrial equipment e.g. for high frequency welding, glass coating, semiconductor production, RF induction ovens, plasma generators or dielectric heating and drying systems.
Each R&S® ESIB combines the high sensitivity, large dynamic range and selectivity of a high-end EMI test receiver with the flexibility and speed of a top-class spectrum analyzer.