CE Mark Testing
Select Subcategory
CE marking is used to indicate that a product meets the European Union's (EU) standards for health, safety, and environmental protection. The CE mark is a requirement for the distribution of a variety of products in the EU. Meeting the safety requirements to receive CE marking is not a standard, but rather a legal requirement of the EU. When a manufacturer marks a product with the CE mark, they are declaring that it meets all of the legal requirements associated with CE marking. The CE mark allows products to be sold within the European Economic Area (EEA) without restrictions.
Rent or purchase equipment to certify your electrical product with the CE Mark from Avalon Test Equipment and Test With Confidence®.
Read More
Read Less
Teseq ITS 6006 Radiated Immunity Test System for IEC 61000-4-3
Integrated signal generator 80 MHz to 6 GHz
Com-Power PC-114 EMC Pre-Compliance Emissions Test System
9 KHz - 1 GHz. Perform Radiated & Conducted EMI pre-compliance testing at your facility up to 1 GHz.
A.H. Systems SAS-560 Passive Loop Antenna
This Loop sensor is built for MIL-STD-461 low-frequency magnetic field testing. 20Hz-2MHz
A.H. Systems SAS-571 Double Ridge Guide Horn Antenna
700MHz to 18GHz. High gain, low VSWR, input handling capability up to 300 watts CW, and rugged design make this horn antenna excellent for both immunity and emissions testing.
A.H. Systems SAS-550-2 Active Directional Antenna
Provides superior performance in electric field measurements. 100 Hz to 60 MHz
A.H. Systems SAS-510-2 Log Periodic Antenna
A compact, lightweight antenna that has been designed to ensure maximum gain, low VSWR and with high power handling capabilities.
Teseq MFO 6501 Manual Power Line Frequency Magnetic Field Generator
The Teseq MFO 6501 Manual Power Line Frequency Magnetic Field Generator complies with IEC/EN 61000-4-8 and magnetic field tests with up to 40 A/m
Teseq SL 50 Strip Line
The transversal electromagnetic mode which can be developped in the SL 50 strip line, provides the opportunity for doing EMC testing inside the strip line. The geometrical dimensions having a line impedance of Z = 50 Ω. At the end is required a 50 Ω termination.
Teseq TPL 3000 Tri-Plate Line
The Tri-Plate test method is specified in the surface vehicle standard SAE J1113-25 ”Electromagnetic Compatibility Measurement Procedure for Vehicle Components-Immunity to Radiated Electromagnetic Fields, 10 kHz to 1 GHz” and applicable for testing products such as air-bag control modules, engine and transmission control modules and other subsystems and their associated cables.
Teseq CMAD 20B Common Mode Absorption Device
The Teseq CMAD 20B Common Mode Absorption Device, 1 MHz to 1 GHz, up to 20 mm cable conforms with CISPR 16-1-4, CISPR 16-2-3, CISPR 11
Teseq CMAD 10 Common Mode Absorption Device for CISPR 22
The Teseq CMAD 10 is a Common Mode Absorption Device designed for CISPR 22 and is ideal for testing in GTEM cells
Teseq KEMA 801A RF Attenuation Clamp/Decoupling Network
The efficient Teseq KEMA 801A RF Attenuation Clamp/Decoupling Network for IEC 61000-4-6 is suitable for high decoupling and can be used on almost any cable
Teseq MDS 21B EMC Absorbing Clamp for Disturbance Power Measuring
Excellent for using as diagnostic tool and for measurements of screening attenuation of coaxial cables. Supplied with 6 dB attenuator and RF cable.
