Tektonix DPO7354 Digital Phosphor Oscilloscope 4 Ch., 3.5 GHz

Applications:

• Signal Integrity, Jitter, and Timing Analysis
• Verification, Debug, and Characterization of Sophisticated Designs
• Debugging and Compliance Testing of Serial Data Streams for Telecom and Datacom Industry Standards
• Low-speed Serial Bus Design (I2C, SPI, RS-232, CAN, LIN, and FlexRay)
• Investigation of Transient Phenomena
• Power Measurements and Analysis
• Spectral Analysis

Characteristics:

• Vertical System:
• Input Channels:  4
• Bandwidth (DSP Bandwidth Enhance): 3.5 GHz
• Rise Time (DSP Bandwidth Enhance): 115 ps
• Hardware Analog Bandwidth (-3 dB): 2.5 GHz
• Rise Time 10% to 90% (Typical): 145 ps
• Rise Time 20% to 80% (Typical): 95 ps
• DC Gain Accuracy: ±1% with offset/position set to 0
• Input Coupling: AC, DC, GND
• Input Impedance (Software selectable):
• 1 MO ±1% with 13 pF ±2 pF or
• 50 O ±1%
• Input Sensitivity: 
• 1 MO: 1 mV/div to 10 V/div
• 50 O: 1 mV/div to 1 V/div
• Vertical Resolution: 8 bit (>11 bit with Hi Res)
• Max Input Voltage:
• 1 MO: ±150 V CAT I, derate at 20 dB/decade to 9 VRMS above 200 kHz
• 50 O: 5 VRMS with peaks less than ±24 V
• Position Range: ±5 divisions
• Offset Range:
• 1 mV/div to 50 mV/div: ±1 V
• 50.5 mV/div to 99.5 mV/div: ±(1.5 V – 10 divisions)
• 100 mV/div to 500 mV/div: ±10 V
• 505 mV/div to 995 mV/div: ±(15 V – 10 divisions)
• 1 V/div to 5 V/div: ±100
• 5.05 V/div to 10 V/div: ±(150 V – 10 divisions)
• Offset Accuracy:
• 1 mV/div to 9.95 mV/div: ±0.2% (offset value-position) ±0.1 div ±1.5 mV
• 10 mV/div to 99.5 mV/div: ±0.35% (offset value-position) ±0.1 div ±1.5 mV
• 100 mV/div to 1 V/div: ±0.35% (offset value-position) ±0.1 div ±15 mV
• 1.01 V/div to 10 V/div: ±0.25% (offset value-position) ±0.1 div ±150 mV
• Delay Between Any Two Channels (Typical): =100 ps (50 O, DC coupling and equal V/div at or above 10 mV/div)
• Channel-to-Channel Isolation (Any 2 channels at equal Vertical Scale Settings) (Typical):
• =100:1 at =100 MHz
• =30:1 between 100 MHz and 2.5 GHz
• > 20:1 between 2.5 and 3.5 GHz
• Time Base System:
• Time Base Range: 25 ps/div to 1000 s/div
• Time Resolution (in ET/IT mode): 250 fs
• Time Base Delay Time Range: 5 ns to 250 s
• Channel-to-Channel Deskew: Range ±75 ns
• Delta Time Measurement Accuracy: ((0.06 / sample rate) + (2.5 ppm × Reading)) RMS
• Trigger Jitter (RMS):
• 1.5 psRMS (typical) with enhanced triggering OFF
• Jitter Noise Floor:
• Time Base Accuracy: ±2.5 ppm + Aging
• Acquisition System:
• Real-Time Sample Rates:
  
• 1 Channel (Max): 40 GS/s
• 2 Channels (Max): 20 GS/s
• 3-4 Channels (Max): 10 GS/s
• Equivalent Time Sample Rate (Max): 4 TS/s (for repetitive signals)
• Maximum Record Length Per Channel:
• Standard Configuration:
• 1 Channel: 50 M
• 2 Channel: 25 M
• 4 Channel: 12.5 M
• Record Length Opt. 2RL:
• 1 Channel: 125 M
• 2 Channel: 50 M
• 4 Channel: 25 M
• Record Length Opt. 5RL
• 1 Channel: 250 M
• 2 Channel: 125 M
• 4 Channel: 50 M
• Record Length Opt. 10RL
• 1 Channel: 500 M
• 2 Channel: 250 M
• 4 Channel: 125 M
• Maximum Duration at Highest Real-Time Resolution (1 Channel):
• Resolution: 25 ps (40 GS/s)
• Max Duration with Standard Record Length and Sample Rate: 1 ms
• Max Duration with Opt 2RL: 2 ms
• Max Duration with Opt 5RL: 5 ms
• Max Duration with Opt 10RL: 10 ms

Spec sheet