Contact us 800.813.8448

Recently added item(s) ×

You have no items in your shopping cart.

Amplifier Research 10WD1000 RF Power Amplifier; 10 watt CW, DC to 1000MHz

Model Number: 10WD1000

Amplifier Research 10WD1000 RF Power Amplifier

Click on above image to view full picture

  • Amplifier Research 10WD1000 RF Power Amplifier
Condition

New

Availability
  • Quote to Rent/Lease
  • Quote to Purchase
Description

Amplifier Research 10WD1000 Rf Power Amplifier, Solid State, 10 Watt CW, DC to 1000MHz

The Model 10WD1000 is a portable, self-contained, air-cooled, broadband, solid state amplifier designed for applications where extensive bandwidth and high gain are required. Push-pull circuitry is utilized in all of the high power stages in the interest of lowering distortion and improving stability. The Model 10WD1000 covers the frequency range from DC to 1000MHz in two bands.


The low band covers from DC to 0.5MHz. The high band covers from 0.5MHz to 1000MHz. These bands can be selected automatically, manually, or by remote control through the remote connector. The 10WD1000, when used with an RF sweep generator, will provide a minimum of 10 watts of swept power. The RF Amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to cooling blockage or fan failure.


There is a digital display on the front panel to indicate the operate status and fault conditions when an over temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared. The 10WD1000 includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides IEEE-488 (GPIB) and asynchronous full duplex RS-232 control of all amplifier functions.


Documentation
Test Standards
  •  
Specifications
  • RATED OUTPUT POWER: 15 watts minimum
  • INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum
  • POWER OUTPUT @ 3dB COMPRESSION, Nominal: 19 watts
  • POWER OUTPUT @ 3dB COMPRESSION, Minimum: 12.5 watts
  • POWER OUTPUT @ 1dB COMPRESSION, Nominal: 17watts
  • POWER OUTPUT @ 1dB COMPRESSION, Minimum: 10 watts
  • FLATNESS: ±1.0dB typical, ±1.5dB maximum
  • FREQUENCY RESPONSE: DC to 1000MHz (In two bands selected automatically, manually or buss)
  • GAIN: 40dB minimum
  • INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
  • OUTPUT IMPEDANCE: 50 ohms, nominal
  • MISMATCH TOLERANCE: 100% of rated output power; will operate without damage or oscillation or foldback with any magnitude and phase of source and load impedance
  • MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
  • HARMONIC DISTORTION: Minus 20dBc maximum at 10 watts
  • THIRD ORDER INTERCEPT POINT: 50dBm typical
  • MAINS (selected automatically): 85 to 264VAC, 47 to 440Hz
  • 500 watts maximum
  • REMOTE INTERFACES: IEEE-488, RS-232
  • COOLING: Forced air (self contained fans)
  • RF CONNECTORS: Type-N on front panel
Standard Accessories Included
  • Calibration certificate
  • Manual
  • Power cord
  • All standard accessories
$0.00

Request a Quote