RF & Microwave

Frequency range from 2 Hz to 4, 7.5, 13.6, 30 or 44 GHz

Multi-touch, 10 MHz–26.5 GHz

Test Port Extension Cable, Armored, with Reinforced Grip, 1.5 meters, N(m) - N(f), 6 GHz, 50 Ω

The ITS 6006 consist of an integrated RF signal generator, RF switch and EUT monitoring interfaces. The unit is designed for various radiated EMC applications in the 80 MHz to 6 GHz frequency range. In addition to the generator, the system includes the AM and PM modulators necessary for EMC testing. The second generation, called ITS 6006B, includes 3 freely configurable pulse modulators (1 µs to 200 s) for radar pulse profiles as required e.g. by Ford FMC1278 or VW TL81000. The RF signal can be switched to one of four outputs, where up to four power amplifiers can be connected directly. Two RF switches are supplied for combining four amplifier into two antenna paths.

20 MHz, 150 MHz

100 MHz–1 GHz, 4 Channels

(4) 1 GHz analog channels and (1) 1 GHz spectrum analyzer input

500 MHz Analog Bandwidth, Spectrum Analyzer up to 6 GHz

Max. frequency range from 100 kHz to 43.5 GHz

20 Hz–40 GHz

input 1, AC coupled: 10 MHz to 7 GHz
input 1, DC coupled: 9 kHz to 7 GHz
input 2, DC coupled: 9 kHz to 1 GHz

Early evaluation of your design's EMI performance is essential for a successful product. The Keysight E7402A EMC Spectrum Analyzer is part of the E7400A Series which provides the capabilities you need in an analyzer to make in-house EMI pre-compliance testing a reality.

General purpose analyzer. Frequency range of 10 Hz to 13.6 GHz.

10 Hz to 4, 7.5, 13.6, 30 or 44 GHz

General purpose analyzer. Frequency range of 10 Hz to 40 GHz.

The Com-Power model PAM-103 Preamplifier (1MHz to 1GHz) is intended for improving measurement system sensitivity during EMC compliance testing.

This high gain preamplifier has a rugged performance over a wide operating frequency range. The added protection of the one watt limiter is an ideal solution when testing in high fields, 20MHz to 18GHz.

The Com-Power PAM-840A is a wideband, high gain, bench top microwave preamplifier; 18GHz to 40GHz.

The Teseq LNA 6000 is a low noise amplifier with 12.5 dB of gain covering the nominal frequency range 1 MHz to 3 GHz and can be used in the range from 200 kHz to 4 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments.

20 MHz - 4 GHz, 24 dB. Will improve overall system sensitivity. Designed to meet the needs of your various testing requirements.

18 - 40 GHz. The Preamplifier will provide reliable, repeatable measurements. An ideal solution to improve system sensitivity for compliance testing.

9 kHz–26.5 GHz

On-site radiomonitoring from 9 kHz to 7.5 GHz

9 kHz to 3 GHz

1 MHz–300 M/500 M/1 G/3 GHz

2GHz to 20GHz

10 MHz–26.5 GHz

10 MHz–26.5 GHz

45 MHz–26.5 GHz

45 MHz–50 GHz

45 MHz–50 GHz

30kHz to 3GHz

9 kHz to 13.2 GHz

250 kHz–3 GHz