IFI GT251-500 TWT Microwave Power Amplifier

• Frequency Range (GHz): 1.0-2.5 GHz
• Rated Power (watts min.): 500W
• Input/Output Impedance: 50 ohms
• RF Input/ Sample Connectors: Type N Female, unless specified otherwise
• RF Output Connector: Type SC or 716 Female up to 8 GHz, 8 – 12 GHz is WR90, 12 – 18 GHz is WR62, 7.5 – 18 GHz is WRD750, 6.5 – 18 GHz is WRD650. Other waveguides available by request or specification (see Option 117)
• Input VSWR: 2.0:1
• Output VSWR: 2.5:1
• Pulse Input: BNC Female Front Panel {TTL into 50 ohms standard} consult factory for special requirements
• Pulse Width Range: Up to CW
• PRF Range: Up to 100 kHz Standard, Higher PRF ranges available consult factory
• Duty Cycle: Up to CW (Higher PRF ranges subject to TWT specification)
• Rise & Fall Time: 25 nsec nominal; 40 nsec maximum
• Pulse to Pulse Jitter: +/- 5 nsec maximum
• Pulse Width Jitter (Distortion: +/- 5 nsec maximum
• Pulse Recovery Time: 150 nsec maximum
• Pulse Delay: 250 nsec maximum / 180 nsec typical
• Pulse Droop: 0.5 dB/100 usecs, 0.1 dB/10 usec
• Power Output Stability: 0.2 dB Pulse to Pulse at constant drive level & PRF
• Pulse On/Off Ratio: 80 dB
• Phase Stability Pulse to Pulse: +/-1 degree nominal
• Temperature: 0º to 50º C operating, -40º to 70º C non-operating
• Humidity: 95% without condensation
• Altitude: 10,000 feet operating, 50,000 non-operating
• Cooling System: Air-cooled, self-contained
• Modulation: All types, AM, FM, Pulse
• Configuration: Rack Mount as specified in Model Table
• Spurious Outputs: <-60 dBc nominal

Datasheet