Power Fail Simulators

The three-phase coupling/decoupling networks of the coupling NX series are used to couple EFT/Burst-, Surge- and Ring wave pulses on DC-lines or to three-phase (4-wire or 5-wire) mains supply systems for voltages up to 1,000 VDC / 3 x 690 VAC.

Haefely AXOS5 Compact Immunity Tester combines 5kV Burst/EFT, Surge combination wave, AC/DC Dips & Interrupts, along with an integrated single-phase coupling/decoupling network (CDN) into one compact system.

Haefely AXOS8 Compact Immunity Test System, 7 kV integrates all of the best features of several stand-alone test systems into one single economic solution. Standards: IEC/EN 61000-4-4, -4-5, -4-9, -4-11, -4-12

Thermo Scientific EMCPro Plus EMC Test System; expandable, portable, multi-function EMC test system for pre-compliance, QA, and full certification testing. Test for up to seven global EMC standards for susceptibility to electromagnetic interference and electromagnetic compatibility with a single instrument.

The Com-Power CDN-AF8E is a Coupling/Decoupling Network designed specifically for testing product for conducted immunity per IEC/EN 61000-4-6.

The Com-Power CDN-C75E is a Coupling/Decoupling Network designed specifically for testing products for conducted immunity per IEC/EN 61000-4-6.

150 MHz - 230 MHz

CDN-M225E is a Coupling/Decoupling Network with a two conductor power cable.

Com-Power CDN-M325ECoupling/Decoupling Network (CDN)

The Com-Power CDN-T2E is a Coupling/Decoupling Network designed specifically for testing product for conducted immunity per IEC/EN 61000-4-6.

The Com-Power CDN-T8 Coupling/Decoupling Network (CDN) is Unshielded/Unscreened cable with 4 balanced conductor pairs,150kHz to 80MHz.

The Com-Power CDN-T8SE is used during conducted emissions or immunity tests on devices with signal/telecom ports intended for connection to shielded (or screened) lines with up to four balanced pairs.

CDN-AF4 4 Unshielded & Unsymmetrical Lines

Series CDN For Unshielded Unsymmetrical Interconnection Lines

The Teseq CAS CDNE Calibration Kit provides measurements for CM impedance and phase angle, VDF, decoupling attenuation and DM impedance

Teseq’s CDN 117 coupling-decoupling network enables convenient testing with surge pulses of 1.2/50 μs on data, signal or peripheral lines, as specified in many product standards.

competitively priced, high performance extension to the NSG 3040 multifunction generator series.

competitively priced, high performance extension to the NSG 3040 multifunction generator series.

CDN 3043 3-phase coupling/decoupling network series as a competitively priced, high performance extension to the NSG 3040 multifunction generator series.

The Teseq CDN 3063 Series fulfills the new requirements for EUT currents over 16 A in the surge standard IEC/EN 61000-4 5:2005 with fully automated IEC and ANSI compliant coupling networks.

100 Amp, 480 Volts

The Teseq CDN 3063 Series fulfills the new requirements for EUT currents over 16 A in the surge standard IEC/EN 61000-4 5:2005 with fully automated IEC and ANSI compliant coupling networks.

Three phase 480 V/63 A automatic coupling decoupling network (CDN) for Surge and Ring Wave pulses up to 6.6 kV

Surge 620 Volt, 100-200 Amp Manual Coupler

The CDN 3083-B100 can couple up to 8.8 kV (5/50 ns – 50 Ohms) EFT pulses simultaneously into the supply lines of the equipment under test (EUT).

The CDN 3425 is Teseq’s newly designed Burst EFT coupling clamp.

Manufactured exactly in accordance with the drawings and specifications of ISO 7637-3 for capacitively coupling the transients onto cables and wiring harnesses. With its characteristic impedance of 50 Ω , connected to the generator via a coaxial cable and terminated on the far side with a 50 Ω load resistor.

The Coupling Decoupling Network is designed for convenient surge testing with 1.2/50 μs pulses, as defined in IEC/EN 61000-4-5, on unshielded symmetrical high speed telecommunication lines e.g. Ethernet.

Designed for IEC/EN 61000-4-6 conducted RF immunity testing with switchable M2 or M3, types with 4 mm banana sockets, and a frequency range of 150 kHz–230 MHz.

10 KHz to 80 MHz for PE Lines

With CEE 7/17 EUT Port & IEC 60320 C14 AE Port

CISPR 16-2-1 and CISPR 15, 150 kHz - 230 MHz

The Teseq CDN M316 is a Coupling/Decoupling Network CDN M3 Type supports a frequency range of 150 kHz - 230 MHz (Optional 10 kHz - 80 MHz)

150 kHz–80 MHz