Preamplifiers

The Com-Power model PAM-103 Preamplifier (1MHz to 1GHz) is intended for improving measurement system sensitivity during EMC compliance testing.

This high gain preamplifier has a rugged performance over a wide operating frequency range. The added protection of the one watt limiter is an ideal solution when testing in high fields, 20MHz to 18GHz.

The Com-Power PAM-840A is a wideband, high gain, bench top microwave preamplifier; 18GHz to 40GHz.

The Teseq LNA 6000 is a low noise amplifier with 12.5 dB of gain covering the nominal frequency range 1 MHz to 3 GHz and can be used in the range from 200 kHz to 4 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments.

The Teseq LNA 6018 is a low noise amplifier with typ. 22 dB of gain covering the nominal frequency range 1 GHz to 18 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments.

The Com-Power PAM-6000 1 - 6 GHz High Gain Preamplifier is intended for improving measurement system sensitivity during EMC compliance testing. It has a frequency range of 1 GHz to 6 GHz. It has gain of 30 dB. Therefore, It amplifies the signals that were previously hidden below the noise floor of the EMI receiver so that it can be seen and measured.

18 - 26.5 GHz

20 MHz - 4 GHz, 24 dB. Will improve overall system sensitivity. Designed to meet the needs of your various testing requirements.

18 - 40 GHz. The Preamplifier will provide reliable, repeatable measurements. An ideal solution to improve system sensitivity for compliance testing.

100 Hz - 1000 MHz, 32dB gain

Com-Power AHA-118 Double Ridge Horn Antenna 700 MHz - 18 GHz